A replica US 1847 Model USMR Colt Walker 44 Calibre Revolver with engraved cylinder, made in Italy, overall length 40cm.

Condition Report

Please see the additional image for the underside of the barrel. This is a non-firing replica with all moving parts, there is a slot in the barrel and holes to each of the chambers of the cylinder.

There are a few minor dings and dents to the wooden hilt, some loss of original finish and patina throughout alongside some small disparate patches of rust, further general wear/scratches to the barrel, including a small noticeable loss of original finish to the fore-end. The action works, revolving on all cylinders and holding at half and full cock, but can be a little sticky. The engraving to the cylinder is generally OK but again there are some sections of wear and scratching to the original patina.

Bidding indicates acceptance of the condition of the lot.  All lots are sold subject to general wear and tear commensurate with age and handling over time and only obvious faults will be mentioned after a visual inspection. If you have particular specialist questions on any lot, please state these before bidding since we cannot and will not provide a forensic examination of any lot but only a general condition report as a guide only. All condition reports given by Halls Holdings Ltd's representatives or agents are statements of opinion and not fact. If you require any further information about any lots in this auction or about bidding please do not hesitate to contact us again.